Bally / Stern · FPGA MPU

SternFA

Bally EE-Era & Stern · FPGA MPU
FPGABally EE EraStern

Drop-in FPGA MPU for Bally EE-era and Stern machines — hardware emulation, fast boot.

$239CADSold out
The SternFA is sold out. We'll email you when the next batch is ready.

What you'll need

  • MicroSD card required (ROMs not included)

Not sure what to get? Ask us and we'll send the exact part list.

Note: See lisy.dev/sternfa for the full compatibility list and FPGA board requirements.
  • Tested before shipping
  • Ships from Canada — no customs
  • Speech board compatible on supported Bally titles
  • Ships in 2 - 3 Business Days · Canada only

All sales final. Boards are bench tested before shipping; make sure your machine has no shorts or wiring faults before installing. Sales policy

About this board

A 1:1 drop-in replacement for Stern MPU boards. FPGA hardware emulation — fast boot, no OS, faithful hardware behaviour.
  • FPGA hardware emulation — no OS or software layer
  • Boot time under 3 seconds
  • DIP sockets pre-installed — no soldering required

Tech specs

TypeFPGA MPU Replacement
CoreXilinx FPGA
EmulationHardware (FPGA)
Boot time< 3 seconds
Form factorBally EE-era / Stern MPU slot (direct drop-in)
ConnectorsOriginal edge connector — no rewiring
NotesCompatible with original speech board on speech-equipped Bally titles. Contact us to confirm compatibility with your specific machine.

Installation

Remove the original MPU board and install the SternFA in the same slot. No jumper changes required. On Bally machines with a speech board, the original speech board remains connected and functional. Contact us before ordering to confirm your specific machine is supported.

Compatible machines

Bally (1977–1985)
Stern MPU-100 / MPU-200

Don't see yours? Ask us — the list grows as firmware is updated.

SternFA — Bally EE-Era & Stern · FPGA MPU | Drop Targets